Godex EZPi-1300 User Manual download pdf (Page 33)

5. Plug in the stripper

connector onto the

switchboard socket. (refer

to right figure)

【

Note

】

There are 2 sockets on the

converting boards (one is for

stripper installation, and

another one is for cutter),

before plug the connector into

socket, please check the pin

first.

6. Place the left side of the

stripper first, and then fit

the right side.

7. Hold the stripper module

and tighten the screws.

8. Feed the label through

the Label Guides.

【

Note

】

The label / paper used

for stripper is suggested to be

at least 20mm in height.

【

Suggestion

】

When printing

with stripper module, it is

suggested to set the stop

position (^E) to 9.

9. Peel off the first label, and

feed the liner through the

roller and the Tear-off

Bar.

EZPi-1000 User’s Manual

32

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 44 45

Comments to this Manuals

No comments